This may be a bit frustrating, but be patient. Once the tabs are into the mounting assembly, turn the disposal so that it locks into place. There are three tabs on the disposal that help it lock into the mounting assembly. Line it up with the mounting assembly under the sink. The plug may fall into your disposal, so be sure that you get it out before proceeding.ġ0. Take out the line plug with a screwdriver and a hammer. This is where the dishwasher inlet line is connected. Find the close-ended tube on the side of the disposal, near the top. If you happen to have a dishwasher then there is an extra step in the process. Next ground the supply wire and replace the electrical cover plate on the unit.ĩ. Rest the disposer on its side underneath the sink. After shutting off the breaker, you need to remove the disposal's cover plate to access the wiring. Connect the white and black wires to the matching wires from the power supply. Plumbers putty will most likely emerge from under the flange, but there's no need to worry just wipe away the excess.Ĩ. Alternate between the three bolts, and make sure that they are evenly tightened. Locate the three mounting bolts and begin tightening them. Now it's time to tighten the mounting bolts. Connect the snap ring to the flange, which will keep the gasket and ring in place.ħ. Take the gasket and the mounting ring and push them up the flange. Find your gasket and mounting ring and head back under the sink. Next, take the sink flange, place it in the drain and press it down carefully onto the putty.Ħ. Open up your plumbers putty and place a quarter-inch coil of putty around the drain. The mounting assembly includes upper and lower mounting rings and mounting bolts. First off, you will need the sink flange and the mounting assembly. Now you can open your new garbage disposal and begin installing it. You want the surfaces to be nice and clean.ĥ. Remove the strainer and make sure to clear away any pre-existing plumbers putty from around the area. You should see a large nut that is securing the strainer. Once the waste lines are removed, you need to remove the mounting assembly. Empty all of the excess water into the bucketģ. Place your bucket under the sink and remove the wastelines. The first task is to disconnect and remove the strainer and all of waste drain lines from the sink.Ģ. Clear everything from under your sink so that there is room to operate.
You should get a professional electrician involved when doing any work that involves your home electrics, as this can be dangerous.1. Depending on the connection, you may just be able to remove it and seal up the wall, but you may need to consult a professional.Īlways remember that when dealing with electronics, you need to turn off your power at the breaker. It's now safe for you to disconnect these wires from the rest of the electrics in your house. Unscrew the ground wire and then disconnect each of the power wires until there are no more connections into your garbage disposal. Use a screwdriver to remove the metal plate on the side of the disposal. Start by disconnecting the wires from your disposal.
In some cases, the garbage disposal is wired directly into your electricity, and you'll need to take a few more steps. If this is the case, you should just be able to unplug it and lift it away with the device. Many modern garbage disposals have a plug attached to the device, which plugs directly into an outlet.